|
|
Data Storage Systems, Inc. offers the full line of QLogic fibre
channel solutions including the QLogic QLA2342L FC Host Bus
Adatper (HBA) . Along with all the QLogic fibre channel products,
DSS, Inc. offers implementation/integration services if needed. For
further information and assistance, please call our sales
department at (763) 416-0474.
Designed and deployed by major server and storage OEMs, the QLogic SANblade QLA2342L host bus adapters (HBAs) offer two independent channels of 2-Gbps Fibre Channel combined with 64-bit, 133-MHz PCI-X. Enabling double IOps with only one PCI/PCI-X slot, the QLA2342L eliminate traditional host bottlenecks that impede the high performance of 2-Gbps Fibre Channel. This union of the fastest I/O and host technologies creates the perfect balanced solution.
Designed and deployed by major server and storage OEMs, the QLogic SANblade QLA2342L host bus adapters (HBAs) offer two independent channels of 2-Gbps Fibre Channel combined with 64-bit, 133-MHz PCI-X. Enabling double IOps with only one PCI/PCI-X slot, the QLA2342L eliminate traditional host bottlenecks that impede the high performance of 2-Gbps Fibre Channel. This union of the fastest I/O and host technologies creates the perfect balanced solution.
QLA2342L-CK
Ships in an individually packed box with a standard
size bracket, a spare low-profile bracket, SANsurfer
FC HBAs CD, and Quick Start Guide.
QLA2342L-HDS-SP
HDS approved configuration. Ships in an individually
packed box with a standard size bracket and a
spare low-profile bracket, HDS Specific SANsurfer
for SANblade FC HBAs CD.
Cost Effective
These HBAs are based on unique, single-chip fibre channel controller architecture from QLogic. For a powerful, scalable solution that maximizes bandwidth and PCI/PCI-X slot usage while maintaining a cost-effective price per port, the QLA2342 is the ultimate choice.If you are looking for low-profile boards for 1U and 2U servers, the QLA2342L, a low-profile version of the QLA2342, is the perfect fit.
Leading Single Chip Integration
The QLA2342L uniquely integrates a RISC processor, a Fibre protocol engine, and transceivers into a single, efficient FC controller chip that increases reliability and performance by lowering CPU utilization.
Broad OEM Acceptance
The QLA2342L HBA is validated by every major OEM including Dell, EMC, HDS, HP, IBM, and Sun. The QLA2342L extensive certification from major server and storage manufacturers makes it the perfect choice for multiplatform requirements.
Simplified Setup
Point-and-click installation and configuration wizards simply the HBA setup process. Storage administrators can quickly deploy HBAs across a SAN using standard HBA management tools and device utilities. The QLA2342L is also fully compatible with industry standard application programming interfaces (APIs), including SNIA HBA API and SMI-S, thereby allowing administrators to manage QLogic HBAs using third-party software applications.
Proven Architecture
The QLA2342L architecture is the result of more than 15 years of progressive development and testing. Proven architecture from QLogic delivers higher overall reliability and enables advanced functionality with its single-chip integration, placing QLogic years ahead of its competitors. The QLA2342L also has proven interoperability with all major software applications, hardware platforms, and operating systems.
The Bottom Line
Driving the standard for interoperability with extensive FC testing in SAN environments, you can feel confident in choosing the QLogic solution.
These HBAs are based on unique, single-chip fibre channel controller architecture from QLogic. For a powerful, scalable solution that maximizes bandwidth and PCI/PCI-X slot usage while maintaining a cost-effective price per port, the QLA2342 is the ultimate choice.If you are looking for low-profile boards for 1U and 2U servers, the QLA2342L, a low-profile version of the QLA2342, is the perfect fit.
Leading Single Chip Integration
The QLA2342L uniquely integrates a RISC processor, a Fibre protocol engine, and transceivers into a single, efficient FC controller chip that increases reliability and performance by lowering CPU utilization.
Broad OEM Acceptance
The QLA2342L HBA is validated by every major OEM including Dell, EMC, HDS, HP, IBM, and Sun. The QLA2342L extensive certification from major server and storage manufacturers makes it the perfect choice for multiplatform requirements.
Simplified Setup
Point-and-click installation and configuration wizards simply the HBA setup process. Storage administrators can quickly deploy HBAs across a SAN using standard HBA management tools and device utilities. The QLA2342L is also fully compatible with industry standard application programming interfaces (APIs), including SNIA HBA API and SMI-S, thereby allowing administrators to manage QLogic HBAs using third-party software applications.
Proven Architecture
The QLA2342L architecture is the result of more than 15 years of progressive development and testing. Proven architecture from QLogic delivers higher overall reliability and enables advanced functionality with its single-chip integration, placing QLogic years ahead of its competitors. The QLA2342L also has proven interoperability with all major software applications, hardware platforms, and operating systems.
The Bottom Line
Driving the standard for interoperability with extensive FC testing in SAN environments, you can feel confident in choosing the QLogic solution.
Ease of Use
Auto-negotiation of Fibre Channel speed bit rate (1 Gbps or 2 Gbps)
Easy detection of activities through an LED panel:
Power
Online
Signal acquired
Loss of synchronization
Firmware error
Automatic topology detection
Quick start guide
Persistent binding
Superior Scalability
Concurrent support for SCSI and IP protocols
Load balancing for optimized performance
Simultaneous initiator and target mode support
Local and remote management
Enhanced Reliability
Unique, single-integrated Fibre Channel controller for added reliability and optimum performanceocal and remote management
Auto-negotiation of Fibre Channel speed bit rate (1 Gbps or 2 Gbps)
Easy detection of activities through an LED panel:
Power
Online
Signal acquired
Loss of synchronization
Firmware error
Automatic topology detection
Quick start guide
Persistent binding
Superior Scalability
Concurrent support for SCSI and IP protocols
Load balancing for optimized performance
Simultaneous initiator and target mode support
Local and remote management
Enhanced Reliability
Unique, single-integrated Fibre Channel controller for added reliability and optimum performanceocal and remote management
Speed
64-bit, 133-MHz PCI-X
Single voltage
3.3 V and 5.0 V buses supported
Compliance
PCI Local Bus Specification rev. 2.2, PCI-X Addendum rev. 1.0a, PCI Hot Plug Specification 1.0, PCI Bus Power Management Interface Specification rev 1.1
Fibre Channel Specifications
Speed
200 MBps per port maximum at half-duplex
400 MBps per port maximum at full-duplex
Topology
FC-AL, FC-AL-2, point to point, switched fabric (FL_Port and F_Port)
Buffer credits
For 512-byte frame size, 9 credits issued.
For 2K-byte frame size, 3 credits issued.
Class of service
Class 3 Fibre Channel service
Protocols
SCSI-FCP, IP, FC-TAPE
Compliance
Second Generation FC Generic Services Definition (FC-GS-2), Third eneration FC Generic Services Definition (FC-GS-3), Fibre hannel-Physical and Signaling Interface (FC-PH), SCSI-3 Fibre Channel Protocol (SCSI-FCP), Fibre Channel-Arbitrated Loop-2 (FC-AL-2), Fibre Channel-Private Loop Direct Attach Technical Report (FC-PLDA), RFC 2625 IP and APR Over Fibre Channel, Fibre Channel Framing and Signaling (FC-FS)
Tools and Utilities
Management tools
FC HBA Manager
Device utilities
Command line interface; configuration utilities resident with BIOS and FCode
Boot support
Intel x86: BIOS (32-bit), EFI (64-bit); Solaris SPARC: FCode
APIs
SNIA HBA API V2, SMI-S, and FDMI
Operating systems*
Windows Server 2003 (32-bit and 64-bit), Windows NT, Windows 2000, Solaris SPARC, Linux (32-bit and 64-bit), Novell NetWare, Mac OS X
* Subject to availability of OS and hardware from respective OEMs.
64-bit, 133-MHz PCI-X
Single voltage
3.3 V and 5.0 V buses supported
Compliance
PCI Local Bus Specification rev. 2.2, PCI-X Addendum rev. 1.0a, PCI Hot Plug Specification 1.0, PCI Bus Power Management Interface Specification rev 1.1
Fibre Channel Specifications
Speed
200 MBps per port maximum at half-duplex
400 MBps per port maximum at full-duplex
Topology
FC-AL, FC-AL-2, point to point, switched fabric (FL_Port and F_Port)
Buffer credits
For 512-byte frame size, 9 credits issued.
For 2K-byte frame size, 3 credits issued.
Class of service
Class 3 Fibre Channel service
Protocols
SCSI-FCP, IP, FC-TAPE
Compliance
Second Generation FC Generic Services Definition (FC-GS-2), Third eneration FC Generic Services Definition (FC-GS-3), Fibre hannel-Physical and Signaling Interface (FC-PH), SCSI-3 Fibre Channel Protocol (SCSI-FCP), Fibre Channel-Arbitrated Loop-2 (FC-AL-2), Fibre Channel-Private Loop Direct Attach Technical Report (FC-PLDA), RFC 2625 IP and APR Over Fibre Channel, Fibre Channel Framing and Signaling (FC-FS)
Tools and Utilities
Management tools
FC HBA Manager
Device utilities
Command line interface; configuration utilities resident with BIOS and FCode
Boot support
Intel x86: BIOS (32-bit), EFI (64-bit); Solaris SPARC: FCode
APIs
SNIA HBA API V2, SMI-S, and FDMI
Operating systems*
Windows Server 2003 (32-bit and 64-bit), Windows NT, Windows 2000, Solaris SPARC, Linux (32-bit and 64-bit), Novell NetWare, Mac OS X
* Subject to availability of OS and hardware from respective OEMs.
$1.745.00
QLA 2342L
© Copyright 2004–2012, Data Storage Systems, Inc.
Dual Port, 2 Gbps, 64 bit, 133 Mhz PCI-X FC HBA
Physical Specifications
Ports
Two
Media
Multimode optic
Optics
Short wave laser
Connections
Two LC-style connectors that support non-OFC, multimode fibre optic cabling using small form factor optical transceiver modules
Form factor
Low-profile MD2: 16.93 cm×5.15 cm (6.7"×2.5")
Bracket size
QLA2342: standard size
QLA2342L: low-profile size
Environment and Equipment Specifications
Airflow
0 lf/m
Temperature
Operating: 0°C/32°F to 55°C/131°F
Storage: –20°C/–4°F to 70°C/158°F
Humidity
Relative (non-condensing): 10% to 90%
Storage: 5% to 95%
Power dissipation
~ 7.0 watts
Cable
50/125µm multimode fiber
62.5/125 µm multimode fiber
Cable distances
1 Gbps: 500 meters 50/125 µm fiber, 300 meters 62.5/125 µm fiber
2 Gbps: 300 meters 50/125 µm fiber, 150 meters 62.5/125 µm fiber
Agency Approvals—Product Safety
US/Canada
UL, cUL: UL60950, CSA C22.2 No.60950, Class 1 Laser Product per DHHS 21CFR J
Europe
73/23/ECC Low Voltage Directive:
TUV: EN60950: 1992+A1,2,3,4,11, EN60825-1: 1994+A11, EN60825-2: 1994
Agency Approvals—EMI and EMC
US
FCC Part 15, Class B
Canada
Industry Canada ICES-003, Class B
Europe
89/336/EEC EMC Directive CE Mark, EN55022: 1998/CISPR22:1997 Class B, EN55024: 1998, EN61000-3-2:1995, EN61000-3-3:1994
Japan
VCCI, Class B
Taiwan
CNS 13438 Class B
New Zealand/Australia
AS/NZS 3548 Class B
Korea
MIC
Ports
Two
Media
Multimode optic
Optics
Short wave laser
Connections
Two LC-style connectors that support non-OFC, multimode fibre optic cabling using small form factor optical transceiver modules
Form factor
Low-profile MD2: 16.93 cm×5.15 cm (6.7"×2.5")
Bracket size
QLA2342: standard size
QLA2342L: low-profile size
Environment and Equipment Specifications
Airflow
0 lf/m
Temperature
Operating: 0°C/32°F to 55°C/131°F
Storage: –20°C/–4°F to 70°C/158°F
Humidity
Relative (non-condensing): 10% to 90%
Storage: 5% to 95%
Power dissipation
~ 7.0 watts
Cable
50/125µm multimode fiber
62.5/125 µm multimode fiber
Cable distances
1 Gbps: 500 meters 50/125 µm fiber, 300 meters 62.5/125 µm fiber
2 Gbps: 300 meters 50/125 µm fiber, 150 meters 62.5/125 µm fiber
Agency Approvals—Product Safety
US/Canada
UL, cUL: UL60950, CSA C22.2 No.60950, Class 1 Laser Product per DHHS 21CFR J
Europe
73/23/ECC Low Voltage Directive:
TUV: EN60950: 1992+A1,2,3,4,11, EN60825-1: 1994+A11, EN60825-2: 1994
Agency Approvals—EMI and EMC
US
FCC Part 15, Class B
Canada
Industry Canada ICES-003, Class B
Europe
89/336/EEC EMC Directive CE Mark, EN55022: 1998/CISPR22:1997 Class B, EN55024: 1998, EN61000-3-2:1995, EN61000-3-3:1994
Japan
VCCI, Class B
Taiwan
CNS 13438 Class B
New Zealand/Australia
AS/NZS 3548 Class B
Korea
MIC
Data Protection,
Storage Networking Systems.
Storage Networking Systems.